Threading through

I learnt that the way to put on a cock ring is to push one ball
through it, then the other, then the cock. For me the first ball
goes through easily. As I try to push the second one through it
hides - it disappears inside me. Only with a lot of coaxing and
pulling the sack does it reappear enough to be pushed through. And
when it come to my cock it hides inside metoo. I pull the
foreskin forward and can push the tip through the ring. Then my
pulling the foreskin through gets it to magically reappear the
right side of the ring. Does this happen to you too?

You can imagine the interest this performance created when trying
on different sized rings at a shop in Cap d'Agde. As everyone
is a nudist there are no fitting rooms. So it was done in the open
shop under the close scrutiny of the female shop keeper.

This topic was edited
RE: Threading through

I use a non metallic stretch type which is soooooo much easier, and more cum-fortable!

This post was edited
RE: Threading through

i purchased also in Cap d'Agde my thick heavy metalone, and it was funny actually trying it in theshop, which was almost like a swinger club itself, even the memories turn mehard again each tie I think on it

This post was edited
RE: Threading through

i have a orange rubber o-ring band i picked up at the hardware store so much easier to put on, i do have a chrome ring that fits behind my helmet that is pretty cool has two ball that rub -massage my inner skin

This post was edited
RE: Threading through

I have a little of the same "hiding ball" issue too. I just keep pulling sac through until it reappears! It's a little hard to describe though. I should make a video of me putting a cock ring on, just for educational purposes of course!

This post was edited
RE: Threading through

Olly, you describe the process perfectly.

This post was edited
RE: Threading through

My problem with the metal rings is that I get aroused putting it on and then I can't get my cock through.

This post was edited
RE: Threading through

My problem with the metal rings is that I get aroused putting it on and then I can't get my cock through.
With the stretch ring you do not have that problem, and still works fine, and looks good too

This post was edited
RE: Threading through

Thanks I knew that and I usually resort to that but I really like the look of metal.

This post was edited
RE: Threading through

I learnt that the way to put on a cock ring is to push one ballthrough it, then the other, then the cock. For me the first ballgoes through easily. As I try to push the second one through ithides - it disappears inside me. Only with a lot of coaxing andpulling the sack does it reappear enough to be pushed through. Andwhen it come to my cock it hides inside metoo. I pull theforeskin forward and can push the tip through the ring. Then mypulling the foreskin through gets it to magically reappear theright side of the ring. Does this happen to you too?Exactly the way I put on my cock ring too. Pulling enough of my sack thru the ring helps get my second testicle thru. And of course if you start to get aroused... forget it! haha Take it off, wait a few minutes then try again! haha

This post was edited
RE: Threading through

I have tried to do my balls first and then my cock, but it seems not to work well, so I now put my cock through first and then the larger of my 2 balls followed by the smaller one. I have had no issues getting a cock ring on after I made these changes. I use metal, leather, rubber, etc have about 25 cock rings and a few head rings to match the cock rings.

This post was edited

Actions

Back to TopicsReply to Topic

Share this topic

Join True Swingers60 second signup
Upgrade Your AccountUpgrade your account!Why Upgrade?
Get CertifiedGet Certified
Become an Affiliate

Get paid just by sending us users/traffic.

Signup takes seconds, start now!

Signup as an affiliate!